*Note this kit does not include the canopy or support arms, but only the mounting hardware that clamps to your roll bar.

The Multi-Kit or Backhoe Kit is a set of our mounting hardware, allowing you to purchase just one canopy, but place it in more than one position or on more than one machine.

The kit includes

• (2) L-Brackets
• (2) U-bolts
• (2) straight steel tubes
• The hardware to bolt these parts together

Backhoe Kit

The Backhoe Kit mounts to your tractor in one of three locations:

1. Above or below the first kit
2. At the same height as the front kit, but on the rear of the roll bar, using only one U-Bolt per side
3. Sandwiched together with the front kit, using only one U-Bolt per side

Then you can quickly slide your Rhinohide Canopy off the front risers and onto the back while you work on your backhoe.

Multi Kit

If you own two different machines (like a zero-turn mower and a tractor), install the second set of mounting hardware to the second machine. Then swap the canopy from one machine to the other as needed.

The widths of both roll bars need to align within 6 inches, but you can measure the inside width of the wider roll bar, and the outside width of the narrower one.

The chances of your two dimensions aligning perfectly is unlikely. So you will need to provide your own bushings/spacers to allow the second machine to align with the width of the canopy arms that were fixed to the shell for the first machine.

This kit is not compatible with Angled Roll Bars.